Layout example¶
A source
This page is a source of edakit – a concept, a prompt or the rules of a session –, shown as it is in the repository. Read it as such; the guides say what edakit does.
Two reviewers check it now, each in a session of its own. The regulatory review is support, not legal advice.
Start each reviewer in a new session when Claude asks.
Who uses the board? The cell comes out by hand, and a swallowed coin cell burns.
- Adults at a desk, out of reach of small children (recommended).
- Children: then a holder that needs a tool.
Adults at a desk
R-2, dark while nobody presses, has no number. At most 1 µA from the cell?
yes
Install EasyEDA Pro. Create the project by hand: File → New → Project, "coin-cell-led". †
† Not with KiCad: there edakit writes the project itself. EasyEDA's interface cannot create one yet; we reported it to EasyEDA (issue #45), and the click goes once it is fixed. The other click, Design → Import Changes, is gone since 2026-11-01: we reported it too (issue #46), and edakit now writes what the import set.
The board's size and shape? And what must stay where a person touches or looks?
Round, please.
Ø 44 mm. The cell nearly in the middle, 10 mm above it to lever it out. Button, LED and resistor below.
